Status: | Available |
SKU: | 256175 |
Vendor: | Kingston |
MPN: | KF318LS11IB/8 |
UPC: | 740617317886 |
EAN: | NO |
Kingston FURY KF318LS11IB/8 is a 1G x 64-bit (8GB) DDR3L-1866 CL11 SDRAM (Synchronous DRAM) 2Rx8, memory module, based on sixteen 512M x 8-bit FBGA components per module. Each module has been tested to run at DDR3L-1866 at a low latency timing of 11-11-11 at 1.35V or 1.5V. Additional timing parameters are shown in the Plug-N-Play (PnP) Timing Parameters section below. The JEDEC standard electrical and mechanical specifications are as follows: Note: The PnP feature offers a range of speed and timing options to support the widest variety of processors and chipsets. Your maximum speed will be determined by your BIOS. FACTORY TIMING PARAMETERS • Default (Plug N Play): DDR3-1866 CL11-11-11 @ 1.35V or 1.5V DDR3-1600 CL10-10-10 @ 1.35V or 1.5V DDR3-1333 CL8-8-8 @ 1.35V or 1.5V FEATURES • JEDEC standard 1.35V and 1.5V Power Supply • VDDQ = 1.35V and 1.5V • 800MHz fCK for 1600Mb/sec/pin • 8 independent internal bank • Programmable CAS Latency: 11, 10, 9, 8, 7, 6 • Programmable Additive Latency: 0, CL - 2, or CL - 1 clock • 8-bit pre-fetch • Burst Length: 8 (Interleave without any limit, sequential with starting address “000” only), 4 with tCCD = 4 which does not allow seamless read or write [either on the fly using A12 or MRS] • Bi-directional Differential Data Strobe • Internal(self) calibration : Internal self calibration through ZQ pin (RZQ : 240 ohm ± 1%) • On Die Termination using ODT pin • Average Refresh Period 7.8us at lower than TCASE 85°C, 3.9us at 85°C < TCASE < 95°C • Asynchronous Reset • Height 1.180” (30mm) w/heatsink |
|
CL(IDD) 11 cycles |
Row Cycle Time (tRCmin) 44.7ns(min.) |